gw_extreme Posted January 26, 2013 Share Posted January 26, 2013 My g1 sliders and knobs have dead zones. the sliders are pretty bad near the top and the bottom... i can move them a lot and have no change to the parameter. does anyone else have this problem, or is my unit defective? Quote Link to comment Share on other sites More sharing options...
Carl_winslow Posted January 27, 2013 Share Posted January 27, 2013 Yea I know what you mean I jus figured maybe those sliders just had no effect on the synth but try and check your tone menu sometimes the other Osc PCM, ext layers are set to off for certain synths... Quote Link to comment Share on other sites More sharing options...
Carl_winslow Posted January 29, 2013 Share Posted January 29, 2013 Sad no one to help us noobs out.... Quote Link to comment Share on other sites More sharing options...
gw_extreme Posted January 30, 2013 Author Share Posted January 30, 2013 yea.. it would be nice Quote Link to comment Share on other sites More sharing options...
Radon_22 Posted January 30, 2013 Share Posted January 30, 2013 Not sure exactly what you guys are asking for. My advice would be to check it out in drawbar organ mode, since not all sliders will be active in other modes. If you're still experiencing issues, then you've got either a bad or damaged unit and need to take the proper steps (return, warranty repair, etc.) Quote Link to comment Share on other sites More sharing options...
Null Posted January 31, 2013 Share Posted January 31, 2013 If I recall correctly, in the Harmony Central thread about the XW it seems that with certain tones and presets the knobs and sliders hit zero at midpoint instead of at the bottom and some values cannot go negative by design.Mike himself mentioned that there.I'm sure once he gets a minute to breathe after NAMM he'll find his way to this thread and comment on it. Quote Link to comment Share on other sites More sharing options...
gw_extreme Posted January 31, 2013 Author Share Posted January 31, 2013 thanks for the answers. the tolerances on the sliders and knobs do seem to be quite wide. when I move a slider, I would say the top 15% and bottom 15% of the movement are dead zones. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.