Jump to content

On the release into PCM tones.


Recommended Posts

I have not experienced this. Do you happen to have a footswitch (pedal) connected? If it has the wrong polarity it acts like you are always pressing it. The default response of the synth is to hold the notes. 

Link to comment
Share on other sites

I'm not sure I'm following you but I will assume the pedal is not the problem. Perhaps it is the way the release changes when adjusting K3? I have noticed myself that it is highly non-linear. Turn it a little right of center to lengthen the release a little bit and there is no perceptible change. Turn it a just a little bit more and it changes the release time by a lot. Go a little further and the release time gets enormous. That's just the way the release times are coded.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.