Hex Layer Volume

[Victormd70]

Is there a way to control volumes of individual layers?

I want the piano to be the master tone. When I add a hex layer, they all overpower the piano tone. How can I correct this?

[Brad Saucier]

Zone volumes can be done different ways.  The quickest way without too much learning how to program controls is this,.....select the zone you want to adjust using the zone buttons.  Press edit>stage setting press enter>zone edit enter>mixer edit enter>go down to volume and adjust using knob 2 or the yes no buttons.  You can also program a slider to do this but that's another story. 

[dc2k]

to change the volume on each of the hex layers, go to edit>tone>layer edit>amp>volume. Then flip between the layers using the zone+ and - buttons.

You'll see the the hex layer you are currently on in the top right. if you zone+/- all the way to the left, you will see 'all' which allows you to adjust the volume of all the layers in sync.

 

There are default stage settings which have the hex layer volumes mapped to the sliders. Select 1:7 or 2:7 and probably more.

Then you could use of these stage settings as a template to create your own or you can map the sliders to the hex layer volumes yourself.