syrupcore Posted January 9, 2015 Share Posted January 9, 2015 Hi, Hopefully I'm just missing something. I have a performance and I've loaded a sequence into it via Edit->Sequence. Hit "Mixer" and turned off all of the reverb and chorus because they didn't suit it. Saved the Performace. As soon as I save, the effect sends are reset to the level before I set them each to zero! Can someone tell me what I'm missing please? Do I need to save the mixer state separately? Tried that and couldn't sort out how to do it. Thanks! 1 Quote Link to comment Share on other sites More sharing options...
Korakios Posted January 9, 2015 Share Posted January 9, 2015 One guess is you have to start everything in performance mode and then tweak anything on sequencer/mixer. But many times ,when switching to mixer mode my performance patch sounds different ,I will definatelly check it ASAP! Quote Link to comment Share on other sites More sharing options...
XW-Addict Posted January 9, 2015 Share Posted January 9, 2015 By editing an performance reverb and chorus send level and saving it wont change the send levels for bothStep sequence and Performance. You need to edit each separate and save them in their own mode. The global reverb and chorus can be set to a level which send to all modes Performance /Tone ./Sseq. Well actually the whole synth. When a step sequence has reverb, chorus in it you can use the mixer and set a send value either to a specific level or to zerofor none for all channel or certain channels and save that particular Step seqeunce. A step sequence pattern can also be programmed how much reverb or chorus it uses by using CC information and a valueto that particular channel using "CTRL" 1 to 4 for that particular pattern channel. If in performance mode a specific value is set for reverb or chorus to channel 1 to 4 will only affect these channelsit won't change any reverb, chorus value from channel 8 to 16. However you can assign the knobs to effect total reverb/chorus and which channel 1 to 4 may be affected by that send value change. 1 Quote Link to comment Share on other sites More sharing options...
syrupcore Posted January 9, 2015 Author Share Posted January 9, 2015 By editing an performance reverb and chorus send level and saving it wont change the send levels for bothStep sequence and Performance. You need to edit each separate and save them in their own mode. That's the ticket. Thank you very much. I didn't realize that there were two different mixers—one for the performance and one for the step sequence. Will try that tonight. Thanks! Quote Link to comment Share on other sites More sharing options...
XW-Addict Posted January 10, 2015 Share Posted January 10, 2015 That's the ticket. Thank you very much. I didn't realize that there were two different mixers—one for the performance and one for the step sequence. Will try that tonight. Thanks!Actually its one mixer that functions for all modes Quote Link to comment Share on other sites More sharing options...
syrupcore Posted January 11, 2015 Author Share Posted January 11, 2015 Thanks again XW-Addict. I'm still trying to grok what goes where and when. After another 'wait, what happened??' today, I scoured the manual again and found a bit in the sequencer section about changing tones (but not in the mixer section!) that says Mixer data is *saved with the step sequence*. On one hand, that makes sense because you don't really use channels 8+ anywhere outside of the sequencer. On the other hand, it seems sorta backwards to me because you set the MIDI channel and internal-vs-external for channels 8+ in the performance. After I understand the topology of the instrument more it may make more sense. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.