Jump to content

Build a Performance patch and then Loop it.


Recommended Posts

https://soundcloud.com/clay-louis-petty/planet-zed-part-1-interstellar-travel

 

XW-G1 is a though little one, Previous I would use anything in a patch or leave out stuff like DSP over control, Global reverb chorus and in combination with Solo synth. End result was quiet a muddy patch and Sseq over time I learned to get the best of parts of the G1 with much desirable result.

 

I got this Planet Zed song setup as follow in performance I got a solo synth on channel 1,

This Ssynth I use as sound fx using white noise in addition I've set arpeggio only to this zone.

Then I used on zone 2 a VA synth and 3 has Sweep choir.

 

And then I program a step sequence first in the sampler build that up to a nice groove and rebuild it again in Sseq. Try to figure out if you can hear the switch between Sample loop and Sseq pattern I'm switching between with. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.