Carl_winslow Posted October 30, 2015 Share Posted October 30, 2015 I was wondering if i could apply a dsp effect on all channels si I can do a sweeping like effect with the filters, Quote Link to comment Share on other sites More sharing options...
BrettM Posted October 31, 2015 Share Posted October 31, 2015 Yes you can. Just enable the DSP line for all the channels you want to effect in the mixer and select the DSP you want. A filter sweep can be accomplished via either the Wah DSP or the Solo Synth filter if you put the Solo Synth in Zone 1. Both have a resonance parameter but the filters aren't the same so you may want to try both and choose the one you prefer. There are a lot more options using the Solo Synth, but you have to dedicate Zone 1 to it. In either case a knob can be set up to do the sweep manually or you can automate it with an LFO. 1 Quote Link to comment Share on other sites More sharing options...
Chas Posted November 1, 2015 Share Posted November 1, 2015 Check the little guide I wrote http://www.casiomusicforums.com/index.php?/topic/6160-using-the-xws-resonant-filter-with-polyphonic-tones/ 1 Quote Link to comment Share on other sites More sharing options...
BrettM Posted November 1, 2015 Share Posted November 1, 2015 A few more suggestions: the solo synth filter can also be automated by a filter envelope as well as/instead of its two LFOs. And the control tracks in the step sequencer can automate filter cutoff on channels 1, 8-16. If the solo synth is not in channel/zone 1, then the normal non-resonant filter of each tone will be swept; but only four channels can be swept this way because there are only four control tracks. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.