pax-eterna Posted January 21, 2016 Share Posted January 21, 2016 I have a slider assigned to control delay, BUT even though in the editor I have set slider one to the delay setting (CC94) whe I action the slider on the PX it also controls the amount of distortion that I actually want to stay constant. Any ideas please? Thanks Quote Link to comment Share on other sites More sharing options...
Brad Saucier Posted January 21, 2016 Share Posted January 21, 2016 This could be one of two things. Check that only 1 target of the slider is assigned to something. Then check the zone controller enable settings. Make sure the slider enable is off for any zone you don't want affected. 2 Quote Link to comment Share on other sites More sharing options...
pax-eterna Posted January 21, 2016 Author Share Posted January 21, 2016 Thanks Brad - can you expand on this please m8 - Check that only 1 target of the slider is assigned to something afaics there is only one target available in the editor screen? Yeah I have the slider , in this case, off for everything other than this specific control on this part. Dennis Quote Link to comment Share on other sites More sharing options...
Brad Saucier Posted January 21, 2016 Share Posted January 21, 2016 You'll see buttons that say 1 and 2 above the word target. Those are the two targets. Quote Link to comment Share on other sites More sharing options...
pax-eterna Posted January 21, 2016 Author Share Posted January 21, 2016 okay thanks - I will check that Quote Link to comment Share on other sites More sharing options...
pax-eterna Posted January 21, 2016 Author Share Posted January 21, 2016 Yep that fixed it thanks - supplementary Q please? I have the volume of the part set to 45, but the expression (which is what the slider is for) is set to 0, however when I load the SS, this part comes on at the preset volume level...seems the expression setting is not recognised when the SS is loaded. It works after loading the SS, but only when I activate the slider manually? I tried using volume (CC7) instead but there is no smooth level transition from 0. IE instead of a gradual level increase you can actually hear the "jump" from off to on...how can I get expression pedal slider setting to actually be active when the SS is loaded? Quote Link to comment Share on other sites More sharing options...
Brad Saucier Posted January 21, 2016 Share Posted January 21, 2016 Correct. Expression is not stored in a stage setting. You will have to use volume if you want the level stored. If the slider min value is set to 0 and the slider is physically in the lowest position when call up the stage setting, it should behave correctly. I'm not entirely sure. Quote Link to comment Share on other sites More sharing options...
pax-eterna Posted January 21, 2016 Author Share Posted January 21, 2016 Cool, thanks Brad. That would explain it when it cannot be saved hahaha! I will use the volume instead. I guess in "real-world" situations the audible jump for 0 to sound on will not matter Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.