nandae Posted February 17, 2018 Share Posted February 17, 2018 Hi friends, I registered on the forum to ask the following question. I really like our px350M, my wife and I both play it. I just ordered a Boss RC-1 loop pedal and was wondering whether I could connect the px350 line outs to the pedal's inputs (it is a stereo pedal) and then run the outputs of the pedal back to the px350's inputs. The idea is to be able to loop stuff I play and have it play back through the piano's speakers. Basically connecting the line outputs to the line inputs with the looper device in between. Just wondering what would be the result when the same signal goes out and comes in all the while playing through the built-in speakers. Thanks a lot for sharing your wisdom! Quote Link to comment Share on other sites More sharing options...
nandae Posted February 21, 2018 Author Share Posted February 21, 2018 The looper arrived and here is what I can share. I connected it as mentioned above with the looper volume knob set to zero and gradually turned it up. It did work at a very low volume. At a certain point a feedback screech kicked in and I knew it was not a good idea. So that's that. Don't do it. I hooked it up to an external powered speaker and it works fine. By the way the looper is much fun. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.