danielk Posted March 8, 2014 Share Posted March 8, 2014 When I connect a line out device to the line in of my AP650, the audio is horribly distorted. For example, I connect an ipod touch line out to the ap650. The only way to get non-distorted audio is to connect it to the headphone out and have the volume output around halfway. However, even when connected this way, I have to turn up the ap650 amplifier past 50% to even get a reasonable level of sound and there is a lot of background hiss at this level. is this normal behavior, or indicative of a faulty unit? 1 Quote Link to comment Share on other sites More sharing options...
danielk Posted March 25, 2014 Author Share Posted March 25, 2014 support/service around? Quote Link to comment Share on other sites More sharing options...
Jared Beaney Posted March 25, 2014 Share Posted March 25, 2014 Hi danielkCan you just clarify how you have the iPod connected? Part of your explanation above isn't quite clear, and suggests you've tried multiple ways of connecting.The only way to do this is headphone output of the iPod connected to Line In of the AP650 with a 3.5mm stereo -> 2x 1/4inch Y cableDouble check you're connected to Line In on the piano, not Line out - it can be easy to mix these up when plugging things in underneath the piano. Quote Link to comment Share on other sites More sharing options...
danielk Posted March 26, 2014 Author Share Posted March 26, 2014 Hi Jared, Thanks for the reply. I've tried connecting the iPod using the dock connector (proper line out) which then connects to 3.5mm to L/R RCA cable which then plugs into an RCA to TS adaptor for each line in input. I went back and redid some tests in order to ensure I was using the Line In, which turned to be true. When connecting the iPod via line out, the output sounded overloaded/distorted, especially when the music was more busy. But even in quiet passages, you could hear the crackle and distortion in the higher frequencies. Immediately switching the connection to the headphone output (max volume) reduced the distortion significantly. Perhaps what was now being heard was distortion from the iPod itself. When turning the volume down to about 80%, then distortion was gone and the music appeared normal. As an additional test, I also connected headphones in all circumstances in order to help isolate the issue. The headphones maintained the same pattern as through the built-in speakers. Based on what I've observed, it seems like the line in cannot handle a regular line input voltage and requires a much lower input voltage that is only available through headphone out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.