CT-S1 SynBrs (Stage Setting for PX-5S) 0.0.1

As described in this comment:

Here is a stage setting for the PX-5S that will send one program change message to the CT-S1 - provided they connected via midi - for it to sound the 1st tone in the Synth category of its tone bank. That tone is called Synth-Brass, hence the name of the stage setting.

Moreover, you will have control over:

• filter cut-off [Slider 1]
• filter resonance [Slider 2]
• attack time [Slider 3]
• chorus [Slider 4]
• delay [Slider 5]
• reverb [Slider 6]

of the CT-S1

and

• use pitch bender
• use modulation wheel

all triggered by the PX-5S.

For the stage setting to send the program change message you may have to press [Bank] and the stage setting-number you saved it under.

For instance, if you saved it under Bank 0-0, you would press [Bank] and [0] [0].

By design, sound generation on the PX-5S is turned off in this stage setting. Likewise, the target (1 & 2) of Knobs 1-4 is not assigned.

Here is an example of the stage setting in use. All music is played on the PX-5S, even though it is the CT-S1 you hear. I used some of the sliders on the PX-5S to slightly alter the sound from the CT-S1:

Jay🎹