Zoli Posted November 1, 2019 Share Posted November 1, 2019 Hi everyone! I am having problems with the pedal 2 setup to switch on and off zones. I would like to use it to switch on and off z3 and z4, and for this in controller edit I disabled pedal 2 for z1 and z2, put it on for z3 and z4, in common edit select zone on/off as a target for pedal 2 with min value 000 and max value127. The zone setup is on for z1 and z2 and off for z3 and z4, after I press pedal 2 z3 and z4 are on, press it again and they remain still on instead of off...Probably I am doing something wrong....if somebody can clear this issue for me, you are welcome. I am new with casio px-5s, but I like it very much anf still learning it. Thank you! rectifying, so when I press second time the pedal 2 z3 and z4 remain active for about 10 second and after they are turned off.... Quote Link to comment Share on other sites More sharing options...
Brad Saucier Posted November 1, 2019 Share Posted November 1, 2019 Check the ON and OFF rates for the pedal. These adjust how long it takes for the value to increase or decrease. It sounds like the pedal is set to a slower rate. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.