using pedal 2 for a stomp box

[dbluemuse]

I have an old leslie simulator (Voce Spin) and it is a toggle on and off with the effect …how do I get this to Pedal 2? what controller number is it? 

thanks

Dave

[Display Name]

This does not go to a pedal input. You send the audio output from the PX-5S into it. 

[Joe Muscara]

I doubt you have a MIDI input on the Spin. Otherwise, you might be able to control it by having the pedal transmit CC. The only external rotary sim I know that has a MIDI input it is the GSi Burn.

[dbluemuse]

thanks for the responses which -of course- opened a whole slew of new questions...

there is both an audio in and an audio out jack on the Spin Voce - so, realizing  I am playing 

4 sounds assigned to 4 zones on the sliders -  is it possible to assign JUST the organ zone and slider to look at the 

headphone out? or ??? is there a separate output to run a line to the VOCE and carry that signal back to the amp?

 

I need really specific step by step directions if this is possible 

Thanking you guys in advance

 

Dave

[Display Name]

The only thing you can do is hard pan the organ to one side of the stereo spread and the other sounds to the other side. Then run cable from the organ side to the box and then to the amp, and the other side straight into the amp. If you use the data editor, the PAN for each zone is real easy to adjust.. it is right below the "ENABLE" button.






So if Zone 1 was your organ, turn that PAN dial all the way to the right and connect the cable going to the box to the right output.

PAN all other zones to the left and run those right into the amp.

Only thing.. do not run any stereo effects as they will mess up the hard panning.